Bently Nevada 330101-00-08-10-02-CN 3300 XL 8mm Proximity Probe

Description

Optimized for continuous, high-reliability machinery protection, the Bently Nevada 330101-00-08-10-02-CN eddy current transducer provides accurate shaft vibration and position measurements in critical industrial rotating equipment. As a core component of the 3300 XL 8mm Proximity Transducer System, this probe converts physical displacement into proportional voltage signals. Engineered with a 3/8-24 UNF thread, a 0.8-inch case length, and a 1.0-meter total cable length, this imperial-threaded sensor is designed to interface with demanding industrial environments while complying with country-specific regulatory approvals.

Features

• Enhanced Dynamic Range: Delivers linear measurement performance of 2.0 mm (80 mils) for high-accuracy shaft radial and axial position monitoring.
• Robust ClickLoc Connector: Utilizes a miniature coaxial ClickLoc connector (02 option) to ensure a secure, vibration-resistant electrical interface with the extension cable.
• Thermal Stability: Built to maintain precise calibration characteristics across a wide temperature range in harsh operating zones.
• Regional Compliance: Certified under CN agency approvals for specialized explosive atmosphere and safety compliance.

Applications

• Steam and gas turbine shaft vibration and axial thrust monitoring.
• Centrifugal compressor radial dynamic motion tracking.
• High-speed industrial pump and generator bearing wear evaluation.
• Hydroelectric turbine shaft centerline and runout measurements.

Ordering Information

Technical Specifications Table

Connections and Interfaces

Alternative Models & Compatibility

The 330101-00-08-10-02-CN probe represents the 1.0-meter configuration of the 3300 XL 8mm series. To build a standard 5.0-meter system, this probe must be paired exclusively with a 4.0-meter extension cable. For a 9.0-meter system, it requires an 8.0-meter extension cable. Mixing components from different overall system lengths (e.g., using a 5-meter system proximitor with 9-meter system cables) will severely alter the electrical calibration curves and void measurement accuracy.

Application Pitfalls & Engineering Notes

When installing in oil-mist or wet-sump conditions, the miniature coaxial ClickLoc connection point is highly susceptible to fluid-borne high-impedance electrical leaks. To prevent signal attenuation and erroneous gap voltage readings, the connection must be sealed inside a dedicated connector protector or wrapped tightly with high-temperature self-fusing silicone tape. Additionally, avoid routing the probe cable close to high-voltage AC lines to prevent magnetic noise induction on the raw RF signal.

Commissioning & Wiring Tips

During the machine gap setting procedure, verify that the probe tip is clear of side-metal interference. Maintain a minimum physical radial clearance of at least 15.0 mm around the 8 mm probe tip to prevent surrounding structures (such as bearing housings or lock washers) from altering the magnetic field. Use a digital multimeter at the Proximitor sensor output to check that the gap voltage settles around -10.0 VDC (the midpoint of the linear range) before final locknuts are torqued.

Installation Guidelines