Bently Nevada 330101-00-36-10-01-00 3300 XL 8 mm Proximity Probe

Description

Option 00 (0.0 in unthreaded length) and Option 36 (3.6 in case length) specify this 330101-00-36-10-01-00 3300 XL 8 mm proximity probe configuration. This non-contact, eddy-current transducer is a core element of the 3300 XL monitoring system, designed for accurate measurement of shaft vibration, axial position, and rotor speed in critical rotating machinery environments.

This probe utilizes the standard 3/8-24 UNF thread profile and is supplied with a 1.0 m length cable terminating in a miniature coaxial ClickLoc connector. It is designed to interface with the 330180 Proximitor Sensor and 330130 Extension Cable. Unlike armored variants, this configuration features standard unarmored cabling suited for protected conduit environments where additional mechanical abrasion resistance is not required.

Features

• 3/8-24 UNF thread for standard installation compatibility.
• 1.0 m total system length including probe lead.
• Miniature coaxial ClickLoc connector (Option 01).
• Standard cable configuration without protective armor.
• Compatible with 3300 XL 8 mm Proximitor sensors and extension cables.
• Option 00 agency approval: Not required.

Applications

This transducer is used for continuous condition monitoring of critical rotating equipment, including steam turbines, gas turbines, centrifugal compressors, fans, pumps, and gearboxes. It provides the input signal for vibration analysis and axial position protection, enabling early detection of machinery degradation.

Ordering Information

Technical Specifications

Installation Guidelines

Ensure the probe is installed with the correct gap as specified by the machinery monitoring configuration. Maintain proper signal path integrity by using 3300 XL compatible extension cables. Probes must be mounted to minimize signal noise, avoiding electrical interference from nearby high-voltage equipment. Ensure all connections are fully seated using the ClickLoc connector mechanism to prevent signal loss.

Compliance and Certifications

This specific part number (Option 00) does not carry hazardous area certifications (CSA, ATEX, or IECEx). It is intended for non-hazardous locations or applications where agency approvals are not required.