Bently Nevada 330104-00-22-10-02-00 3300 XL 8 mm Proximity Probe

Description

330104-00-22-10-02-00 is a 3300 XL 8 mm proximity probe featuring an M10 x 1 thread and integrated stainless steel armor for mechanical protection in harsh industrial environments. This configuration includes 0.0 mm unthreaded length (Option 00), a 220 mm case length (Option 22), and a 1.0 meter total system length (Option 10), utilizing a standard miniature coaxial ClickLoc connector (Option 02) without agency approvals (Option 00).

The 3300 XL 8 mm transducer system provides accurate, non-contact measurement of shaft vibration and axial position on rotating machinery. The probe consists of a probe tip, case, connector, and cable, designed to provide a linear output voltage proportional to the distance between the probe tip and the observed conductive target. This system is fully compatible with 3300 XL Proximitor sensors and extension cables to ensure specified interchangeability and performance across the monitoring chain.

Features

• M10 x 1 threaded probe body with integrated stainless steel armor for increased durability and abrasion resistance.
• Option 00: 0.0 mm unthreaded length configuration (fully threaded).
• Option 22: 220 mm case length.
• Option 10: 1.0 meter total system length (probe plus cable).
• Option 02: Miniature coaxial ClickLoc connector with standard cable for reliable, vibration-resistant connections.
• Option 00: No hazardous area agency approvals required.
• High-temperature rating suitable for demanding machinery protection applications.

Applications

• Shaft vibration and axial position monitoring in industrial rotating machinery.
• Turbine, compressor, and pump train monitoring.
• Applications requiring armored cables for mechanical protection against oil, abrasion, or environmental debris.
• Heavy-duty industrial environments where M10 x 1 mounting is required.

Ordering Information

Technical Specifications

Installation Guidelines

• Ensure the probe tip is installed with the correct initial gap as specified by the machinery monitoring system configuration (typically -1.25 V DC or specific gap distance).
• Tighten the ClickLoc connector finger-tight; do not use pliers to avoid damaging the connector mechanism.
• Route cables through conduit or cable trays to minimize electromagnetic interference and physical damage.
• Ensure probe thread engagement does not exceed 15 mm for M10 x 1 threads to prevent binding.
• The Proximitor sensor must be installed in a protected, dry location, ideally within an approved weatherproof housing.