Bently Nevada 330130-040-02-00 3300 XL Standard Extension Cable

Description

Option 040 (4.0 m cable length) and Option 02 (standard cable with connector protector, without agency approvals) specify this 3300 XL series standard extension cable configuration — 330130-040-02-00.

This specific cable configuration integrates a miniature coaxial ClickLoc connector shielded by a fluorosilicone connector protector. This design helps prevent moisture ingress, dust, and physical damage at the probe-to-extension cable connection point without requiring additional armor. The 4.0-meter length combines with a 1.0-meter probe to establish a 5.0-meter transducer system calibrated for 5-meter 3300 XL Proximitor sensors.

Unlike armored options (such as B-options 01 or 03) that feature flexible stainless steel armor, the 330130-040-02-00 uses an unarmored 75 Ohm triaxial cable with FEP insulation, maintaining a tight 25.4 mm (1.0 in) minimum bend radius for routing flexibility in narrow conduits while relying on its fluorosilicone protector to shield the ClickLoc joint from environmental hazards.

Features

• Option 040 provides a 4.0-meter (13.1 feet) physical cable length for mid-range system reaches.
• Option 02 includes a pre-installed fluorosilicone connector protector to guard the probe-to-cable junction against oil, dust, and moisture.
• FEP (fluorinated ethylene propylene) insulation delivers stable dielectric performance across standard operating temperatures.
• Gold-plated ClickLoc connectors provide a secure, low-resistance coaxial coupling with tactile "click" feedback.
• Option 00 specifies that agency approvals are not required, simplifying standard industrial configurations.

Applications

• Rotating machinery monitoring systems (shaft vibration, axial position)
• Steam turbines, gas turbines, and large industrial compressors
• Petrochemical facilities, power generation plants, and water treatment operations
• Machine enclosures requiring unarmored cable routing in protective conduits

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

To establish a stable machinery protection loop, observe the following engineering parameters during installation:

• Maintain a physical cable bend radius of no less than 25.4 mm (1.0 in) to prevent internal conductor damage and phase shifts.
• Join the gold-plated coaxial ClickLoc connectors finger-tight. The maximum rated connector-to-connector tightening torque is 0.565 N-m (5 in-lbf).
• Ensure the fluorosilicone connector protector is fully seated over the coaxial junction to seal out machine lubricants and environmental moisture.
• Route cables away from high-voltage electrical conduits to minimize electromagnetically induced noise in the transducer loop.

Compliance and Certifications

This product configuration (Option 00) is intended for use in environments where hazardous area approvals are not required. The component is manufactured under ISO 9001 strict quality management controls for machinery protection systems.