Bently Nevada 330103-00-06-05-12-05 3300 XL 8 mm Proximity Probe

Description

Fully threaded M10 x 1 metric steel probe body (Option 00) with a 60 mm overall case length (Option 06) and 0.5 m FluidLoc cable (Option 05) featuring a ClickLoc connector (Option 12) defines this 330103-00-06-05-12-05 3300 XL 8 mm proximity probe.

Option 12 specifies a FluidLoc cable without armor, which blocks fluid leakage along the cable interior when deployed inside pressurized machinery casings. The M10 x 1 metric thread mounts directly into tapped machinery housings. Option 05 designates CSA, ATEX, and IECEx approvals for hazardous areas.

Features

• M10 x 1 Threaded Case: Standard metric thread interface (without armor) for direct mounting in tapped holes.
• FluidLoc Cable Option: Cable design blocks oil or other fluids from leaking out of the machine casing through the cable interior.
• 0.5-Meter Length: Short-lead configuration optimized for compact enclosures or immediate connections to an extension cable.
• 0 mm Unthreaded Length: Fully threaded body style allowing maximum adjustment range within the mounting bracket or machine casing.
• CSA/ATEX/IECEx Certified: Approved for hazardous environments under standard international directives.
• Gold-Plated ClickLoc Connector: Miniature coaxial connector with gold plating for signal transmission integrity.

Applications

• Fluid-film bearing machine vibration monitoring
• Radial shaft vibration and axial rotor position measurements
• Turbine, compressor, pump, and gearbox shaft motion analysis
• Speed and Keyphasor reference measurements in industrial rotating machinery

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

• Ensure the probe tip has at least 20 mm clearance from adjacent metal to prevent cross-talk and side-loading errors.
• Clean and inspect the tapped M10 x 1 mounting hole before threading the probe to prevent thread binding.
• Thread engagement should not exceed 15 mm to prevent mechanical interference.
• Tighten the probe case to the recommended torque of 7.5 N-m (66 in-lbf).
• Maintain a minimum cable bend radius of 25.4 mm (1.0 in) for both probe cable and extension cable routing.
• Ensure the ClickLoc connector is finger-tight during final assembly.

Compliance and Certifications

This proximity probe is certified under option code 05 for use in hazardous areas. Approved standards include:

• CSA: Class I, Division 1, Groups A, B, C, and D
• ATEX: Zone 0/1/2, Ex ia IIC Ga/Gb
• IECEx: Zone 0/1/2, Ex ia IIC Ga/Gb