Siemens 6AV7260-1GA10-1AX0 SIMATIC IPC677D Panel PC

Description

This Siemens 6AV7260-1GA10-1AX0 is a SIMATIC IPC677D Panel PC designed for demanding industrial applications. It features a 19-inch touch display with a resolution of 1366 x 768 pixels and a convenient front-mounted USB port. The system is powered by an Intel Xeon E3-1268LV3 processor, supported by 2 GB of DDR3 RAM and a 500 GB SATA HDD for storage. Integrated system monitoring for temperature, fans, and a watchdog timer ensures operational reliability. The unit includes an AC 110/230V industrial power supply and comes pre-installed with Windows 7 Ultimate 32-bit.

Features

• 19-inch resistive touch display
• Intel Xeon E3-1268LV3 processor (4 Cores, 8 Threads)
• 500 GB SATA Hard Disk Drive (HDD)
• 2 GB DDR3 1600 DIMM system memory
• Onboard RAID controller for data redundancy
• Integrated watchdog, temperature, and fan monitoring
• Dual Gigabit Ethernet ports (10/100/1000 Mbit/s)
• Pre-installed Windows 7 Ultimate 32-bit SP1 (MUI)
• Industrial-grade 110/230V AC power supply with NAMUR compliance

Applications

• Human-Machine Interface (HMI) for process control
• Data acquisition and logging systems
• Machine vision and quality control stations
• Factory floor automation and SCADA nodes
• Industrial diagnostics and monitoring terminals

Technical Specifications

Installation Guidelines

1. 1 Prepare Mounting Location: Ensure the panel cutout dimensions are correct and the mounting surface is clean, flat, and can support the weight of the unit (17.00 kg). Verify adequate clearance for ventilation and cable routing.
2. 2 Mount the Panel PC: Insert the Panel PC into the cutout from the front. Secure it using the provided mounting clamps, tightening them evenly to ensure a proper seal and prevent chassis distortion. Do not overtighten.
3. 3 Establish Protective Earth (PE) Connection: Connect a low-impedance protective earth conductor to the designated PE terminal on the chassis. This is a critical safety connection and must be established before any other wiring.
4. 4 Connect I/O and Communication Cables: Connect Ethernet, USB, and serial communication cables as required. Ensure all connectors are fully seated and secured. Route cables away from high-voltage lines to minimize electrical noise interference.
5. 5 Connect Power Supply: With the main power source de-energized, connect the AC power cable to the unit's power input. Verify the source voltage (110V or 230V AC) matches the power supply rating.
6. 6 System Power-Up: After verifying all connections are correct and secure, remove the LOTO device and energize the main power source. Power on the Panel PC and proceed with software configuration.