Bently Nevada 330106-05-30-50-02-00 3300 XL 8 mm Reverse Mount Proximity Probe

Description

Option 05 (5.0 mm unthreaded length), Option 30 (30 mm overall case length), and Option 50 (5.0 m total length) specify this 3300 XL 8 mm reverse mount proximity probe configuration — 330106-05-30-50-02-00.

This probe features metric M10 x 1 threads and is used with a 3300 XL Proximitor sensor and extension cable. The reverse mount design is suited for applications where the probe must be installed from the rear or inside a housing. This configuration uses a 5.0 m standard coaxial cable with a miniature ClickLoc connector, bypassing the need for a connector protector. Unlike sibling variants that require agency approvals, this model is specified without hazardous area certifications (Option 00).

Features

• M10 x 1 metric thread configuration for threaded housing installations.
• 5.0 mm unthreaded length combined with a 30 mm overall case length.
• 5.0 m (16.4 feet) standard coaxial cable length.
• Miniature coaxial ClickLoc connector (no connector protector).
• Reverse mount mechanical housing design.
• Operating temperature range from -52 degC to +177 degC.

Applications

• Shaft vibration and position measurements on rotating machinery.
• Radial vibration, axial position, and speed measurements on steam turbines, gas turbines, compressors, pumps, and gearboxes.
• Industrial environments requiring space-saving reverse-mount thread geometry.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

• Verify the probe mounting clearance is sufficient to support a reverse mount geometry.
• Ensure the target surface size matches or exceeds the 8.0 mm probe tip diameter requirements for calibration consistency.
• Avoid exceeding the metric thread engagement limits during probe installation.
• Maintain a minimum bend radius of 25.4 mm (1.0 inch) for standard coaxial cables to prevent signal loss.

Compliance and Certifications

This specific configuration (Option 00) does not carry hazardous area certifications (unapproved). It is intended for general-purpose applications where certified safety barriers or explosion-proof ratings are not required.