Description

The 106765-13 interconnect cable is a specialized signal transmission component designed for use with Bently Nevada Velomitor XA piezo-velocity sensors. This cable assembly provides reliable signal routing from the sensor to the terminal housing or monitoring equipment. It features a 2-conductor twisted, shielded design to protect signal integrity from electromagnetic interference in industrial environments. The cable is constructed with stainless steel armor to provide mechanical protection against abrasion and harsh operating conditions typical of rotating machinery monitoring applications. It terminates in a 2-pin Mil-C-26482 hermetically-sealed connector, ensuring compatibility with the Velomitor XA sensor interface. When properly installed with matching components, the assembly supports NEMA 4X and IP-65 environmental ratings.

Features

• 13.0 m (42.6 ft) total cable length
• 2-conductor twisted, shielded 22 AWG wiring
• Stainless steel armor for mechanical protection
• 2-pin Mil-C-26482 connector
• Compatible with Bently Nevada Velomitor XA sensor systems
• Designed for moist and harsh industrial environments

Applications

The 106765-13 interconnect cable is used in critical machinery monitoring systems, particularly for velocity measurements in industrial settings such as:

• Power generation facilities
• Oil and gas processing plants
• Petrochemical and chemical manufacturing
• Water and wastewater treatment infrastructure
• Rotating equipment protection (pumps, fans, motors, and turbines)

Ordering Information

Option	Code	Description
Orderable Part Number	106765-13	Interconnect Cable for Velomitor XA Sensor
A - Length in metres	13	13.0 metres (42.6 feet)

Technical Specifications

Manufacturer	Bently Nevada (Baker Hughes)
Part Number	106765-13
Cable Type	2 conductor, twisted, shielded
Conductor Gauge	22 AWG (0.382 mm2)
Connector Type	2-pin Mil-C-26482
Outer Protection	Stainless steel armor
Environmental Rating	IP-65, NEMA 4X (when installed)

Installation Guidelines

Ensure the cable is routed away from high-voltage lines to prevent signal interference. Secure the cable using appropriate clamps or conduits to minimize vibration-induced wear. The stainless steel armor provides protection against direct contact, but care should be taken to avoid exceeding the minimum bend radius during installation. Ensure the Mil-C-26482 connector is fully seated and tightened to maintain the hermetic seal required for moist environments.