Bently Nevada 330130-085-01-00 3300 XL Standard Extension Cable

Description

330130-085-01-00: This 3300 XL Standard Extension Cable features an 8.5-meter cable length (Option 085) and integrated stainless steel armor (Option 01) without agency approvals (Option 00). It is used to connect 3300 XL 8 mm proximity probes to a 3300 XL Proximitor Sensor, completing the transmission path for eddy-current displacement measurements in machinery protection systems.

The stainless steel armor (Option 01) provides mechanical shielding against physical damage, abrasion, and aggressive industrial environments, unlike standard unarmored configurations. This configuration utilizes a 75 Ohm triaxial FEP-insulated design and corrosion-resistant, gold-plated ClickLoc connectors to maintain signal integrity over the entire 8.5-meter length.

Features

• 8.5-meter cable length (Option 085) for long-distance sensor connections.
• Integrated flexible stainless steel armor (Option 01) with FEP outer jacket.
• Gold-plated ClickLoc connectors that require finger-tight installation only.
• 75 Ohm triaxial design with fluorinated ethylene propylene (FEP) insulation.
• CableLoc design providing high strain relief and connection durability.

Applications

• Steam and gas turbine shaft vibration and axial position monitoring.
• Centrifugal compressor casing and shaft alignment measurements.
• Industrial gearbox, fan, and pump machinery protection systems.
• Heavy machinery monitoring in environments requiring rugged armored cabling.

Ordering Information

Technical Specifications

Installation Guidelines

To ensure proper signal performance and connection longevity, observe the following engineering guidelines during installation:

• Always maintain the minimum cable bend radius of 25.4 mm (1.0 in) to prevent internal coaxial damage.
• Ensure that the sum of the probe length and extension cable length matches the designated total system length of the Proximitor Sensor (e.g., a 9.0 m Proximitor requires a 0.5 m probe and an 8.5 m extension cable).
• Connectors should be tightened finger-tight until they click. Do not use tools on gold ClickLoc connectors unless mating to a non-XL stainless steel connector.
• Ensure the armored FEP jacket is routed away from sharp structural edges and high-voltage power lines to minimize mechanical wear and electrical noise.

Compliance and Certifications

This specific variant (Option 00) is intended for applications where hazardous area approvals are not required. For certified installations, please specify Option 05 (CSA, ATEX, IECEx approvals).