Bently Nevada 330101-00-77-15-02-05 3300 XL 8 mm Proximity Probe

Description

The Bently Nevada 330101-00-77-15-02-05 is a high-performance 8 mm proximity probe belonging to the industry-standard 3300 XL 8 mm Proximity Transducer System. This non-contacting eddy-current sensor is engineered for critical machinery protection, offering precise shaft vibration and position measurements. This specific configuration features a 0.0-inch unthreaded length, a 7.7-inch overall case length, a 1.5-meter (4.9 feet) total cable length, and standard unarmored triaxial cabling with a miniature ClickLoc coaxial connector. It is fully certified for hazardous area operations with CSA, ATEX, and IECEx approvals (-05 option).

This proximity probe is designed to operate seamlessly in demanding rotating machinery environments, transmitting physical displacement signals to a 3300 XL Proximitor sensor (such as the 330180 series) and standard extension cables. It performs exceptionally well in turbomachinery, pumps, and compressors, enabling early fault detection through continuous vibration, axial position, and speed measurements.

Features

• 8 mm tip diameter optimized for non-contacting eddy-current displacement measurement
• Robust polyphenylene sulfide (PPS) tip construction for superior environmental protection
• Corrosion-resistant AISI 303 or 304 stainless steel probe body built to withstand harsh machine casings
• Unarmored 75 ohm triaxial cable with a miniature ClickLoc coaxial connector for stable signal integrity
• Certified under international hazardous area standards (CSA, ATEX, and IECEx approvals)
• Fully compatible with Bently Nevada 3300 XL monitoring chains and 3500 series rack systems

Applications

• Steam and gas turbine shaft vibration and position monitoring
• Compressor and high-pressure pump rotor displacement measurement
• Hydroelectric and generator shaft radial vibration tracking
• Thrust bearing wear detection in critical industrial machinery
• Permanent machinery protection and condition monitoring

Ordering Information

Technical Specifications

Installation Guidelines

Ensure standard engineering practices are followed during installation:

• Mount the probe with the appropriate probe gap per system calibration, typically gapped at 1.27 mm (50 mils) for standard operation with a 3300 XL Proximitor sensor.
• Ensure the minimum cable bend radius of 25.4 mm (1.0 in) is not violated during routing.
• Apply a maximum case torque of 33.9 N-m (300 in-lbf) during installation on forward-mounted configurations, or 7.5 N-m (66 in-lbf) for the first three threads.
• Route the cable with proper shielding and grounding practices to prevent electrical noise in vibration monitoring environments.
• Avoid excessive thread engagement beyond industry standard guidelines to prevent binding or physical damage.

Compliance and Certifications

• CSA: Approved for hazardous areas per drawing 141092 / 140979
• ATEX/IECEx: Ex ia IIC T5...T1 Ga, Ex ia IIIC T90 degC...T280 degC Dc, Ex nA IIC T5...T1 Gc, Ex ec IIC T5...T1 Gc
• Entity Parameters: Ui = -28 V, Ii = 140 mA, Pi = 0.91 W, Ci = 1.5 nF, Li = 610 uH