Bently Nevada 330103-06-25-10-02-00 3300 XL 8 mm Proximity Probe

Description

330103-06-25-10-02-00 specifies this 3300 XL 8 mm proximity probe configuration, which features an M10 x 1 metric thread, 60 mm of unthreaded length, a 250 mm overall case length, and a 1.0 meter total cable length without mechanical armoring. The unit terminates in a standard miniature coaxial ClickLoc connector with standard 75 Ohm coaxial cabling.

This metric unarmored probe variant is designed for installations requiring deep case penetration (250 mm total) with a 60 mm smooth, thread-free tip clearance. Unlike variants that utilize a connector protector (Option 01) or FluidLoc water-blocking cables (Option 12), this configuration employs a standard coaxial interface (Option 02) and carries no agency approvals (Option 00) for general-purpose applications.

Features

• M10 x 1 metric thread with an unarmored brass and stainless steel sheath.
• 60 mm unthreaded length (Option 06) and 250 mm overall case length (Option 25).
• 1.0 meter (3.3 feet) standard coaxial cable (Option 10).
• Gold-plated miniature coaxial ClickLoc connector without connector protector (Option 02).
• No regional agency hazardous area approvals required (Option 00).
• Fully compatible with standard 3300 XL extension cables and 5-meter/9-meter Proximitor sensors.

Applications

• Shaft vibration and axial position measurements on fluid-film bearing rotating machinery.
• Radial dynamic vibration monitoring in industrial compressors, steam turbines, and large utility pumps.
• Keyphasor phase reference and speed sensing applications.
• Metric-threaded installations requiring high reach with thread-free clearance up to 60 mm.

Ordering Information

Technical Specifications

Installation Guidelines

• Ensure the probe's case thread engagement does not exceed 15 mm during mounting to avoid binding.
• Ensure the minimum clearance distance to surrounding metal is maintained according to system calibration specifications.
• Hand-tighten ClickLoc coaxial connectors only; do not use pliers unless standard stainless steel adapters require them.
• Secure cables using appropriate mechanical mounting clamps to prevent operational vibration wear.

Compliance and Certifications

• CE compliant
• RoHS compliant
• Note: This specific configuration (Option 00) does not include ATEX, CSA, or IECEx approvals.