Bently Nevada 330101-00-08-20-02-05 3300 XL 8 mm Proximity Probe

Description

The Bently Nevada 330101-00-08-20-02-05 is a high-performance 8 mm proximity probe belonging to the industry-standard 3300 XL 8 mm Proximity Transducer System. This specific configuration features a fully threaded 0.8-inch case (0.0 inches of unthreaded length) and a 2.0-meter (6.6-foot) standard coaxial cable with a ClickLoc connector, offering certified CSA, ATEX, and IECEx hazardous area approvals. Engineered for fluid-film bearing machinery, this extremely compact housing configuration is optimized for installations with severe spatial constraints where standard longer probes cannot fit.

Operating on the eddy-current principle, this non-contacting sensor provides precise dynamic vibration and static position measurements of critical rotating shafts. It pairs seamlessly with a 3300 XL extension cable and a 330180 Proximitor sensor, providing an output voltage directly proportional to the gap between the probe tip and the target surface. The rugged polyphenylene sulfide (PPS) tip and robust stainless steel body protect the sensing coil from industrial turbine oils and moisture, ensuring permanent mounting reliability on bearings, casings, and brackets.

Features

• 8 mm tip diameter optimized for non-contacting eddy-current displacement measurement.
• Fully threaded 0.8-inch stainless steel case designed for highly restricted, low-profile mounting spaces.
• 2.0-meter standard coaxial cable without armor, terminating in a robust gold-plated ClickLoc connector.
• Fully compliant with hazardous area requirements with ATEX, IECEx, and CSA certifications.
• Complete interchangeability within the Bently Nevada 3300 XL monitoring chain without requiring recalibration.
• Viton O-ring pressure seal design for reliable containment of bearing housing environments.

Applications

• Steam and gas turbine shaft vibration monitoring.
• Compressor and pump rotor axial displacement and radial vibration tracking.
• Bearing housing clearances and critical rotating machinery protection.
• Keyphasor phase reference and speed measurement.

Ordering Information

Technical Specifications

Installation Guidelines

Ensure the mounting bracket or bearing casing provides a clean, dry thread match for the 3/8-24 UNF housing. Mount the probe with the appropriate physical gap (typically set to -9 Vdc or approximately 1.27 mm / 50 mils for radial vibration measurements) relative to the target shaft. When threading the probe, do not exceed the maximum recommended thread engagement of 0.563 inches to prevent binding or mechanical damage. Route the 2.0-meter standard cable through conduit or appropriate trays, ensuring proper shielding and grounding practices to avoid electrostatic noise interference. If the probe-to-cable connection is exposed to fluid or turbine oil, the use of connector protectors or silicone tape is recommended.

Compliance and Certifications

This 3300 XL proximity probe is certified for hazardous environments under the option code 05, complying with international standards including ATEX, IECEx, and CSA. It is designed for use in intrinsically safe and non-incendive environments when connected with approved Bently Nevada Proximitor sensors and safety barriers.