Bently Nevada 330101-00-59-10-01-05 3300 XL 8 mm Proximity Probe

Description

Option 00 (0.0 in unthreaded length) and Option 59 (5.9 in overall case length) specify this 3300 XL 8 mm proximity probe configuration - 330101-00-59-10-01-05. It serves as a non-contact eddy-current displacement sensor within 3300 XL transducer systems, enabling shaft vibration and axial position monitoring. By pairing with a 330180 series 3300 XL Proximitor sensor and an extension cable, the probe translates the physical gap between its tip and a target material into a proportional voltage signal.

The 330101-00-59-10-01-05 proximity probe is unarmored and features a 1.0 m total length lead. It utilizes standard coaxial cable with a miniature ClickLoc connector and includes an integrated connector protector (Option 01). Certified with CSA, ATEX, and IECEx approvals (Option 05), it is configured for safety-critical environments and hazardous area installations.

Features

• 8 mm tip diameter designed for non-contact eddy-current displacement measurement
• Threaded 3/8-24 UNF steel body without protective armor sleeve
• Option 00 specifies a 0.0 inch unthreaded length, making the entire 5.9 inch case threaded
• Option 59 provides a 5.9 inch overall case length for deep-reach installation requirements
• Option 10 provides a 1.0 meter total probe length
• Option 01 features a miniature coaxial ClickLoc connector supplied with a connector protector and standard cable insulation
• Option 05 qualifies the probe with international CSA, ATEX, and IECEx hazardous area certifications

Applications

• Steam and gas turbine shaft vibration measurement
• Compressor rotor axial position and dynamic displacement monitoring
• Industrial pump shaft alignment and radial vibration checks
• Machinery protection systems for large rotating equipment assemblies

Ordering Information

Technical Specifications

Installation Guidelines

• Mount with the appropriate probe gap per system calibration, ensuring the probe tip has adequate side view clearance and tip-to-tip spacing.
• Always use the provided connector protector to shield connections from moisture and contaminants in machine casings.
• Observe the minimum permissible cable bend radius of 25.4 mm (1.0 inch) during routing.
• Implement proper shielding and grounding practices to minimize electrical noise interference in the vibration monitoring signal path.
• Tighten standard coaxial ClickLoc connectors finger tight only to avoid thread or contact damage.

Compliance and Certifications

• CSA Class I, Div 1 / Class I, Div 2
• ATEX Zone 0 / Zone 2
• IECEx