iC2-30FA3N04-02A2E20F4+ACXX Danfoss iC2-30 Frequency Converter

Product Overview

The 132L6117 (132L6117) is a precision-engineered iC2-30 series frequency converter designed to optimize motor control in compact industrial applications. This air-cooled drive is a critical component for machinery manufacturers in sectors such as food and beverage processing, material handling, and textile production. By providing a stable 0.75 KW output with advanced three-phase modulation, the iC2-30 series effectively reduces mechanical stress and energy consumption. Its compact IP20 design allows for high-density mounting within control cabinets, ensuring maximum uptime and reliability for low-power automated systems where space and thermal efficiency are paramount.

Technical Configuration

The hardware architecture of the 132L6117 follows the robust iC2-30 platform standards, focusing on simplified integration and high power density.

• Phase & Voltage Logic: Configured for three-phase (3N) mains input ranging from 380-480 VAC, making it compatible with global industrial power standards.

• Thermal Management: Employs a specialized air-cooled (FA) category design, utilizing optimized airflow paths to maintain component integrity during continuous 2.2 A operation.

• Protection & Compliance: Features an IP20/Open type (E20) protection rating, intended for clean, dry cabinet environments. The integrated F4 filter ensures compliance with C4 category EMC requirements.

• Brake Logic: This specific variant (+ACXX) does not include an integrated brake chopper, making it an economical and streamlined choice for applications with low-inertia loads that do not require rapid deceleration or regenerative braking.

Technical Specifications

Technical FAQs

Does the 132L6117 support permanent magnet motors?

Yes, the iC2-30 series is designed to control both high-efficiency permanent magnet (PM) motors and standard asynchronous induction motors, allowing for flexible system upgrades.

What are the mounting clearance requirements for this air-cooled drive?

For the 132L6117, ensure a minimum vertical clearance of 100 mm above and below the unit to allow for unrestricted airflow through the heat sink, especially when mounting multiple drives in a single row.

Can this drive be used in a C1 or C2 EMC environment?

The integrated filter is rated for C4 (F4 category). For environments requiring C1 or C2 compliance, an external RFI filter must be installed on the mains side to suppress electromagnetic interference to the required levels.

Engineering & Installation Guide

• Cabinet Thermal Budgeting: Despite its small 0.75 KW rating, ensure your cabinet's total heat load calculation accounts for the drive's heat dissipation at full 2.2 A load. In high-density installations, forced ventilation of the enclosure is recommended to prevent the drive from entering a thermal derating state.

• Wiring for EMC Compliance: To maintain the C4 EMC rating, motor cables must be shielded. The shield should be terminated using a high-frequency 360-degree clamp at both the drive and the motor end. Avoid "pigtail" grounding, as this significantly increases high-frequency impedance.

• Line Protection: Use recommended fast-acting fuses or a circuit breaker sized for the 380-480 VAC input. Ensure that the short-circuit current rating (SCCR) of the installation site does not exceed the drive's rated capacity to prevent catastrophic failure during a fault.