Bently Nevada 330103-00-06-10-01-00 3300 XL 8 mm Proximity Probe

Description

Option 00 (0 mm unthreaded length) and Option 01 (ClickLoc connector with connector protector, standard cable) specify this 3300 XL 8 mm metric probe configuration — 330103-00-06-10-01-00.

Unlike variants configured with the standard coaxial connector (Option 02) or FluidLoc water-blocking cable, this assembly features an integrated connector protector designed to shield the ClickLoc coaxial junction from industrial fluids and physical damage. The 60 mm overall case length is fully threaded with an M10 x 1 metric thread and has no protective armor sleeve, pairing with a 1.0 m lead cable for non-contact eddy-current shaft displacement and position measurements.

Features

• M10 x 1 metric thread body without protective armor.
• 0 mm unthreaded case length, providing a fully threaded body.
• 60 mm overall case length for standard machine casing depths.
• 1.0 meter (3.3 feet) total cable length.
• Miniature coaxial ClickLoc connector with pre-installed connector protector.
• Gold-plated brass and gold-plated beryllium copper contacts for signal integrity.
• Standard FEP-insulated coaxial cable jacket.
• Polyphenylene sulfide (PPS) probe tip material for industrial process resistance.

Applications

• Non-contacting eddy-current vibration sensing in machinery protection systems.
• Radial shaft vibration, axial thrust position, and speed measurements on rotating shafts.
• Monitoring critical assets including steam turbines, gas turbines, compressors, and gearboxes.
• Fluid-film bearing clearance monitoring in standard industrial installations.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

• Observe a minimum cable bend radius of 25.4 mm (1.0 in) to protect the internal FEP insulation.
• Avoid over-tightening the probe case; the maximum rated torque for an M10 x 1 probe case is 22.6 N-m (200 in-lbf), with a recommended installation torque of 7.5 N-m (66 in-lbf).
• Use a thread-locking compound or safety wire with the lock nut to prevent mechanical loosening under severe machinery vibration.
• Ensure coaxial connectors are completely clean and dry before mating. Hand-tighten the Gold ClickLoc connectors until they click; do not use pliers.
• Maintain adequate side clearance of at least three probe diameters of flat surface area around the probe tip to prevent cross-talk or calibration errors from surrounding metal.

Compliance and Certifications

• Hazardous Area Approvals: Option 00 specifies agency approval is not required.
• RoHS compliant.