Bently Nevada 330103-00-06-05-02-00 3300 XL 8 mm Proximity Probe

Description

The 330103-00-06-05-02-00 is an 8 mm proximity probe from the 3300 XL transducer system, specifically configured with an M10 x 1 thread and a 60 mm case length. This non-contact, eddy-current displacement transducer is engineered for measuring shaft vibration and axial position on critical rotating machinery. As an unarmored probe configuration, it provides precise signal transmission for monitoring and diagnostic applications where mechanical cable protection is not required.

This unit features a 0.5 meter total system length and a standard miniature coaxial ClickLoc connector, ensuring compatibility with 3300 XL Proximitor sensors and extension cables. The absence of agency approval (Option 00) makes this specific configuration suitable for standard industrial environments where certified hazardous area protection is not mandated.

Features

• M10 x 1 Thread (330103): Metric threaded housing for compatible mounting brackets and machine ports.
• 0.5 m Total Length: Optimized for short-reach installations within the monitoring chain.
• Miniature ClickLoc Connector: Standardized connector interface for secure, reliable mating with 3300 XL extension cables.
• Unarmored Configuration: Designed for standard indoor or protected industrial environments without additional abrasive protection.
• 0 mm Unthreaded Length: Fully threaded case design for flexible positioning in mounting clamps.

Applications

• Turbine and compressor shaft vibration monitoring
• Rotor axial position measurement
• Critical rotating machinery protection
• General eddy-current displacement sensing

Ordering Information

Technical Specifications

Installation Guidelines

Ensure that the probe is installed using the appropriate M10 x 1 mounting bracket. Maintain correct gap distance from the target surface as specified in the 3300 XL system manual. Verify that the cable is routed away from high-noise electrical equipment and secured properly to prevent mechanical stress on the ClickLoc connector. Ensure the probe and extension cable system length matches the 0.5 m calibration of the Proximitor sensor.