Siemens 6AV7260-0AA10-0AX3 SIMATIC IPC677D Panel PC

Description

This is a Siemens 6AV7260-0AA10-0AX3, a SIMATIC IPC677D series Panel PC designed for industrial automation and control applications. It is equipped with a 15-inch touch display with a 1280 x 800 resolution and is powered by an Intel Celeron G1820TE 2.2 GHz processor. The system includes 2 GB of DDR3 RAM, a 500 GB SATA HDD for storage, and an onboard RAID controller for data redundancy. Connectivity is provided by dual Gigabit Ethernet ports, four USB 3.0 ports, and a serial COM port. This unit comes pre-installed with Windows 7 Ultimate (32-bit) and is powered by an AC 110/230V industrial power supply.

Features

• 15-inch TFT touch display (1280 x 800)
• Intel Celeron G1820TE dual-core processor (2.2 GHz)
• 2 GB DDR3 1600 DIMM system memory
• 500 GB SATA Hard Disk Drive
• Dual 10/100/1000 Mbit/s Ethernet interfaces
• Four rear USB 3.0 ports and one front-accessible USB port
• Integrated watchdog, temperature, and fan monitoring
• Onboard RAID controller for storage management
• Pre-installed Windows 7 Ultimate 32-bit SP1 (MUI)
• Two available PCI expansion slots

Applications

• Human-Machine Interface (HMI) for process visualization
• Supervisory Control and Data Acquisition (SCADA) systems
• Industrial data logging and analysis
• Machine control and monitoring on the factory floor
• Control room operator stations

Technical Specifications

Installation Guidelines

1. 1 Panel Mounting: Prepare the panel cutout according to the device's mechanical drawings. Ensure the mounting surface is flat, clean, and provides adequate support for the unit's weight. Secure the Panel PC into the cutout using all provided mounting clamps, tightening them evenly to the specified torque to ensure a proper seal.
2. 2 Protective Earth (PE) Connection: Connect the designated PE terminal on the chassis to the main panel or cabinet protective earth bus using a low-impedance conductor. This connection is critical for safety and electromagnetic compatibility (EMC).
3. 3 Power Connection: Connect the AC power supply cable to a stable, correctly rated power source. Ensure the input voltage (110/230V AC) matches the local supply. Use appropriate strain relief for the power cable to prevent accidental disconnection.
4. 4 I/O and Network Cabling: Connect Ethernet, USB, and serial cables as required. Route all signal and communication cables separately from high-voltage power lines to minimize electrical noise interference. Use shielded cables for network connections where specified.
5. 5 System Power-Up: After verifying all connections, remove LOTO devices and apply power to the unit. Observe the boot sequence to ensure the operating system loads correctly. Proceed with application-specific software configuration.