Bently Nevada 330930-040-02-00 Kabel Ekstensi 3300 NSv

Description

Option 040 (4.0 m cable length) and Option 02 (stainless steel armor, without FEP jacket) specify this 3300 NSv extension cable configuration — 330930-040-02-00.

This 3300 NSv extension cable provides a secure electrical path in tight-clearance non-contact vibration and displacement measurement setups. It interfaces with 3300 NSv probes and 330980 Proximitor sensors, forming a calibrated transducer system for high-speed machinery with restricted target footprints. The armored construction provides mechanical protection against wear without adding the extra weight or bulk of plastic outer jackets.

Features

• Cable Length Option: 4.0 meters (13.1 feet) for calibrated system length configuration.
• Connector and Cable Option: Bare stainless steel armor without FEP jacket (Option 02) to resist crush and abrasive forces.
• Agency Approval Option: Not required (Option 00) for standard, non-hazardous industrial environments.
• Signal Stability: 75 ohm coaxial cable minimizes noise and transmission losses.
• Physical Flexibility: 25.4 mm (1.0 in) minimum bend radius allows installation in narrow conduits and spaces.
• Stable Interface: Gold-plated brass ClickLoc coaxial connectors ensure secure mechanical and electrical coupling.

Applications

Typical applications include:

• Small-bore rotating machine vibration monitoring
• High-speed machinery with restricted physical clearances
• Aeroderivative gas turbine installations
• Compressors and gearboxes with limited sensor footprints

Ordering Information

Technical Specifications

Installation Guidelines

For correct system installation, observe the following engineering guidelines:

• Total System Length: Ensure the sum of probe length and extension cable length matches the designated Proximitor Sensor system length (e.g., 5.0 m or 7.0 m).
• Cable Routing: Maintain a minimum bend radius of 25.4 mm (1.0 in). Avoid routing near high-voltage lines or sharp edges that can breach the bare stainless steel armor.
• Connector Care: Ensure ClickLoc connectors are clean and dry before mating. Hand-tighten (finger tight) only. Do not exceed 0.56 Nm (5 in-lb) of torque.
• Moisture Protection: Apply silicone self-fusing tape or connector protectors to prevent fluid ingress at the connection point.

Compliance and Certifications

No agency approvals are required under Option 00. For hazardous environments, please consult configurations with Option 05 approvals.