Siemens 6AV7240-4DL34-1PA0 SIMATIC IPC 477D Panel PC

Description

The Siemens 6AV7240-4DL34-1PA0 SIMATIC IPC 477D Panel PC is a fanless industrial computing platform designed for continuous operation in harsh environments. It integrates a 19-inch resistive touch display with a 4:3 aspect ratio, powered by an Intel Core i3-3217UE processor. The unit provides 4 GB of RAM with integrated NVRAM and an 80 GB MLC SSD for data integrity. Pre-installed with Windows Embedded Standard 7 and licensed for WINAC RTX 2010 and WINCC RT Advanced, it serves as a dedicated controller and visualization terminal for distributed control systems.

Features

• Fanless cooling design for maintenance-free operation
• 19-inch XGA TFT display with analog resistive touch
• Intel Core i3-3217UE processor, 1.6 GHz
• 4 GB DDR3 RAM with integrated NVRAM backup
• 80 GB Solid State Drive (Multi-Level Cell)
• PROFIBUS DP 12 Mbps master interface
• Dual Gigabit Ethernet (IE/PN) ports
• RS-232 serial interface for legacy device integration
• Four rear USB 2.0 ports, one front USB 2.0 port
• 24 V DC industrial power supply input

Applications

• Machine-level Human Machine Interface (HMI)
• Distributed Control System (DCS) operator stations
• PC-based soft PLC control (WINAC RTX)
• Data acquisition and recipe management
• Manufacturing Execution System (MES) clients
• Building automation control panels

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

1 Verify panel cutout dimensions match the 19-inch format. Ensure rear clearance of at least 100 mm for cable bending radius and heat dissipation.

2 Connect the 24 V DC power line using appropriately sized ferrules. Torque M4 terminal screws to 0.8 N-m. Reverse polarity protection is active, but incorrect wiring may trigger internal fuses.

3 Ground the chassis via the PE (Protective Earth) terminal on the power connector. Use a copper conductor with minimum cross-section of 2.5 mm². Do not rely solely on DIN rail grounding for EMC compliance.

4 For PROFIBUS DP termination, activate the built-in terminating resistor via DIP switch if the unit is the last node on the bus segment. Set the PROFIBUS address via hardware DIP switches prior to applying power.