Bently Nevada 177230-02-01-05 is a self-contained seismic vibration transmitter for measuring overall casing or bearing-housing vibration. Its integrated sensing and signal-conditioning electronics provide a loop-powered 4–20 mA output that can be connected to a suitable PLC, DCS or condition-monitoring analog input without a separate monitor rack.
Technical specifications
| Manufacturer |
Bently Nevada |
| Part number |
177230-02-01-05 |
| Measured variable |
Overall vibration velocity |
| Full-scale range |
0 to 50.8 mm/s RMS (0 to 2.0 in/s RMS) |
| Frequency option |
10 Hz to 1 kHz RMS |
| Output |
Two-wire 4–20 mA proportional signal |
| Approval option |
05 — Multiple Approvals; confirm supplied nameplate for the installation |
| Housing |
Stainless-steel industrial transmitter body |
| Approximate net mass |
0.131 kg |
Selection, wiring and commissioning
- Confirm that the control-system analog input is configured for a powered two-wire 4–20 mA loop and scaled to 0–50.8 mm/s RMS.
- Mount the transmitter on a clean, flat, rigid machine surface. Poor surface preparation or a loose mounting stud attenuates higher-frequency vibration.
- Route a shielded twisted pair away from motor leads and variable-frequency-drive output cables; follow the site grounding practice to avoid loop noise.
- The 05 suffix identifies an approval option, but installation method, barriers, glands and area classification must be checked against the actual nameplate and project drawings.
- This transmitter reports an overall vibration value. It does not provide the waveform and phase information available from a full dynamic monitoring channel.
Dimensions and shipping
Product envelope: approximately 25.4 mm diameter × 66 mm high; net mass approximately 0.131 kg. Estimated packed size: 15 × 10 × 8 cm. Estimated shipping weight: 0.4 kg. Confirm carton and gross weight before air shipment.