Bently Nevada 990-05-50-01-05 is a two-wire, loop-powered vibration transmitter that converts the signal from a 3300 NSv proximity-probe system into a proportional 4–20 mA output. It is intended for continuous radial-vibration trending and basic machinery monitoring through a PLC, DCS or other current-loop input.
Ordered configuration and specifications
| Manufacturer |
Bently Nevada |
| Part number |
990-05-50-01-05 |
| Input system |
3300 NSv proximity probe and extension cable |
| Full-scale vibration range |
05 — 0 to 5 mil peak-to-peak (0 to 127 µm pp) |
| System length |
50 — 5.0 m |
| Mounting |
01 — 35 mm DIN-rail clips |
| Approvals |
05 — Multiple Approvals; verify the supplied nameplate |
| Loop supply |
+12 to +35 VDC |
| Output |
Two-wire 4–20 mA proportional to vibration |
| Frequency response |
5 Hz to 6 kHz |
| Loop accuracy |
±1.5% of full scale under reference conditions |
| Diagnostic output scale |
7.87 mV/µm (200 mV/mil) at PROX OUT |
Selection, wiring and commissioning
- Use a matched 5 m 3300 NSv probe-plus-extension-cable system. A 9 m transducer chain is not the same calibration.
- Set the probe in the documented linear gap region and verify the PROX OUT voltage before scaling the 4–20 mA channel.
- Calculate available loop resistance from the actual supply voltage, barriers, cable resistance and analog-input burden.
- PROX OUT exposes the dynamic proximity signal for setup and troubleshooting; use isolated test equipment where required to prevent ground loops.
- The 05 approval suffix must be confirmed on the actual label. It does not replace the project’s hazardous-area loop and installation assessment.
Dimensions and shipping
Approximate product dimensions: 100.1 × 73.9 × 58 mm; transmitter mass approximately 0.43 kg. Estimated packed size: 20 × 15 × 12 cm. Estimated shipping weight: 1.0 kg. Confirm the actual carton before shipment.