Description

This is a Siemens 6AV7724-2AA00-0AA0 SIMATIC Panel PC 670, an industrial-grade human-machine interface (HMI) designed for panel mounting. This standard configuration features a 15.1-inch color TFT touchscreen display, powered by a Celeron 1.2 GHz processor. It is equipped with 256 MB of SDRAM-133 and a 40 GB EIDE hard disk drive for data storage. The unit requires a 24V DC power supply for its power supply box and front panel. This model is delivered without a pre-installed operating system, allowing for custom software installation based on application requirements.

Features

• 15.1-inch color TFT display with integrated touchscreen
• Celeron processor operating at 1.2 GHz
• 256 MB SDRAM (133 MHz) installed as a single module
• 40 GB EIDE internal hard disk drive
• Integrated power supply box for 24V DC input
• Supplied without an operating system

Applications

• Machine-level visualization and control
• Process monitoring in manufacturing environments
• Data acquisition and logging systems
• Operator control stations for automated lines
• SCADA client applications

Technical Specifications

Installation Guidelines

1. 1 Panel Cutout and Mounting: Prepare the control cabinet panel cutout according to the device's mechanical drawings. Ensure the mounting surface is clean, flat, and rigid. Install the Panel PC into the cutout and secure it evenly using all provided mounting clamps to maintain the specified ingress protection rating.
2. 2 Protective Earth (PE) Connection: Connect the chassis to the control cabinet's protective earth system using a low-impedance conductor. This is critical for operator safety and electromagnetic compatibility (EMC). Use the designated PE terminal on the device.
3. 3 Power Supply Wiring: Connect a stable, filtered 24V DC power source to the designated power input terminals. Verify correct polarity (+/-) before energizing the unit. Use appropriate wire gauges for the current draw and route power cables separately from high-voltage or signal cables to minimize noise.
4. 4 Ventilation and Clearance: Ensure adequate ventilation clearance around the rear of the unit as specified by the manufacturer. Obstructed airflow can lead to overheating and premature component failure. Do not block ventilation slots.
5. 5 Initial Power-Up: After all connections are verified, re-apply power to the cabinet. The Panel PC should boot to its BIOS screen or a prompt for an operating system installation. Proceed with the required software setup.