Bently Nevada 330104-02-12-50-02-00 3300 XL 8 mm Proximity Probe

Description

330104-02-12-50-02-00: 3300 XL 8 mm proximity probe with M10 x 1 metric thread and protective stainless steel armor, specifying Option 02 (20 mm unthreaded length), Option 12 (120 mm overall case length), Option 50 (5.0 m total length), Option 02 (miniature coaxial ClickLoc connector, standard cable), and Option 00 (no agency approvals required).

This specific configuration features an integrated stainless steel armor sleeve over the 5.0-meter cable to safeguard against mechanical wear, abrasion, and debris in industrial environments. Calibrated for 5.0-meter total system length, the probe must pair directly with a 5-meter Proximitor sensor (without an extension cable) or another compatible configuration to perform non-contact shaft vibration and axial position measurements on critical rotating machinery.

Features

• Metric M10 x 1 Threaded Case: Provides robust mechanical installation directly into machine housings.
• Stainless Steel Armor: Wraps the standard coaxial cable to protect against abrasion and physical impacts.
• 20 mm Unthreaded Section: Includes a 20 mm unthreaded sleeve to facilitate deep-bore mounting scenarios.
• 5.0-Meter Total Cable Length: Eliminates the need for a separate extension cable when used in 5-meter monitoring loops.
• Gold-Plated ClickLoc Connector: Miniature coaxial male connector provides reliable connection with low signal loss.

Applications

• Shaft vibration and axial position measurement on fluid-film bearing machines.
• Speed and Keyphasor reference measurements on steam turbines, gas turbines, and compressors.
• Industrial gearbox, generator, and high-power pump condition monitoring systems.
• Mechanical protection of rotating shafts in harsh industrial environments requiring armored cables.

Ordering Information

Technical Specifications

Installation Guidelines

Ensure that the probe case M10 x 1 threads are properly engaged without exceeding the maximum recommended torque to avoid thread binding. Maintain an appropriate gap within the linear range of the transducer system (typically 1.27 mm or 50 mils for mid-range calibration). Since this probe has a 5.0-meter integral cable, connect it directly to a 5-meter Proximitor sensor without using an extension cable. Lay out the armored cable with a minimum bend radius of 25.4 mm (1.0 in) to prevent damage to the inner coaxial core.

Compliance and Certifications

This product configuration is certified to comply with general electrical and manufacturing standards. Option 00 specifies that no hazardous area or explosion-proof certifications are included or active on this specific probe configuration.