Bently Nevada 146031-01 3500/22M 10Base-T/100Base-TX I/O Module

Description

The Bently Nevada 146031-01 is a 10Base-T/100Base-TX Ethernet I/O Module designed for providing Ethernet interface connectivity and system contact interface functions for the 3500/22M Transient Data Interface (TDI) within the 3500 Machinery Monitoring System. Mounted in the rear slot directly behind the 3500/22M TDI main module, it features an RJ-45 Ethernet port supporting BN Host Protocol and BN TDI Protocol over TCP/IP to route steady-state and dynamic waveform data to host software such as System 1 Condition Monitoring and Diagnostic software. The 146031-01 incorporates an onboard OK Relay for rack status annunciation, system contact inputs for Trip Multiply, Alarm Inhibit, and Rack Reset, as well as a dedicated 2-pin Signal Common terminal for instrument ground connection.

Features

• Autosensing 10Base-T or 100Base-TX Ethernet communication via RJ-45 connector
• Integrated standard OK Relay rated for 5A @ 24 Vdc/120 Vac for rack fault annunciation
• Built-in arc suppressors for relay contact protection
• Terminal inputs for Trip Multiply, Alarm Inhibit, and Rack Reset dry contact system controls
• Dedicated 2-pin connector for connecting Signal Common to single point Instrument Ground
• Direct rear-slot interface for the 3500/22M Transient Data Interface (TDI) module

Applications

• Bently Nevada 3500 Machinery Protection Systems
• Ethernet communication and host software interfacing via System 1
• Remote rack monitoring and transient waveform data acquisition
• Critical machinery monitoring in power generation, oil and gas, and petrochemical facilities

Technical Specifications

Installation Guidelines

• Install the module into the single full-height rear slot directly behind the 3500/22M TDI main module.
• Follow proper upgrade procedures when replacing a RIM I/O: remove RIM, remove RIM I/O, insert TDI I/O, and insert TDI to prevent module damage.
• Connect standard Category 5 shielded Ethernet cable with RJ-45 connectors up to a maximum length of 100 metres (328 feet).
• When connecting Signal Common to a single-point instrument ground using the 2-pin connector, slide the selector switch on the side of the Power Input Module (PIM) toward the "HP" arrow to isolate Signal Common from chassis ground.

Compliance and Certifications

• EMC: European Community Directive 2014/30/EU; Standards: EN 61000-6-2, EN 61000-6-4
• Electrical Safety: European Community Directive 2014/35/EU; Standard: EN 61010-1
• RoHS: European Community Directive 2011/65/EU
• FCC: Complies with part 15 of the FCC Rules
• Maritime: DNV GL rules for classification; ABS Rules for Condition of Classification, Part 1
• Hazardous Area Approvals: cNRTLus (Class I, Zone 2: AEx/Ex nA nC ic IIC T4 Gc / Class I, Zone 2: AEx/Ex ec nC ic IIC T4 Gc / Class I, Division 2, Groups A, B, C, D); ATEX/IECEx (II 3 G Ex nA nC ic IIC T4 Gc / Ex ec nC ic IIC T4 Gc)