Description

The 16710-07 is an armored interconnect cable designed for use with Bently Nevada acceleration transducer systems, specifically the 330400 and 330425 series. This cable features a 3-conductor shielded 22 AWG (0.5 mm2) configuration, engineered to maintain signal integrity in demanding industrial environments where mechanical protection is required. This specific configuration, 16710-07, provides a total cable length of 7 feet (2.13 meters), ending in a 3-socket plug at the transducer interface and terminal lugs at the monitor or junction box interface. As an essential component in condition monitoring chains, the 16710-07 ensures reliable transmission of vibration data from the sensor to the monitoring instrumentation. The rugged armored jacket provides resistance against abrasion and incidental impact common in rotating machinery applications, such as gearboxes, motors, and pumps.

Features

• Length: 7 feet (2.13 meters)
• Cable Type: 3-conductor shielded 22 AWG (0.5 mm2) armored cable
• Connectors: 3-socket plug at one end, terminal lugs at the other
• Shielding: Integrated shield to minimize electromagnetic interference (EMI)
• Durability: Armored jacket for enhanced mechanical protection
• Compatibility: Designed for use with 330400 and 330425 accelerometer transducers

Applications

• Casing vibration monitoring on critical rotating machinery
• Gear mesh monitoring in gearboxes
• General-purpose industrial acceleration measurements
• Harsh environments requiring abrasion-resistant cabling

Ordering Information

Orderable Part Number	16710-07	330400/330425 Interconnect Cable
Cable Length	07	7.0 ft (2.13 m)

Technical Specifications

Manufacturer	Bently Nevada
Part Number	16710-07
Conductor Size	22 AWG (0.5 mm2)
Shielding	Shielded
Armor	Armored
Length	7.0 ft (2.13 m)
Connector (Transducer End)	3-socket plug
Connector (Termination End)	Terminal lugs

Installation Guidelines

• Ensure the mating connector provides IP54 ingress protection or better if installed in hazardous areas.
• Route cables in protected conduit to prevent physical damage and electrical noise interference.
• Avoid sharp bends near the connector assembly to maintain seal integrity and prevent conductor fatigue.
• Use the provided terminal lugs for secure, low-resistance connections at the monitor or junction box termination point.
• Check that the total cable run does not exceed the system limitations for signal degradation.

Compliance and Certifications

• RoHS Directive 2011/65/EU
• China RoHS: EFUP designation of 15 years (SJ/T 11364-2024)