Bently Nevada 330103-00-16-10-02-05 3300 XL 8 mm Proximity Probe

Description

330103-00-16-10-02-05: 3300 XL 8 mm proximity probe, configured with a 1.6 inch case length (Option 16), 1.0 m total system length (Option 10), and integrated stainless steel armor for increased mechanical durability. This probe serves as a primary non-contact sensor within the 3300 XL monitoring system, providing continuous voltage output proportional to the gap between the probe tip and the observed conductive surface.

The 330103 configuration utilizes a 3/8-24 UNF thread and is designed for compatibility with 3300 XL Proximitor sensors and extension cables. The inclusion of Option 05 approvals allows for installation in hazardous area environments governed by CSA, ATEX, and IECEx standards. This probe is frequently deployed in critical rotating machinery applications, including steam and gas turbines, centrifugal compressors, and industrial pumps, for shaft vibration and axial position measurement.

Features

• Option 16: 1.6 in (40 mm) case length for specific mounting depth requirements
• Option 10: 1.0 m (3.3 ft) total system length, allowing connection to extension cables or direct-to-Proximitor integration
• Option 02: Miniature ClickLoc connector with standard cable
• Option 05: Agency approval covering CSA, ATEX, and IECEx hazardous area requirements
• Integrated stainless steel armor provides protection against abrasive industrial fluids and mechanical damage
• 8 mm probe tip diameter compatible with standard 3300 XL series monitoring systems

Applications

• Turbine and compressor shaft vibration monitoring
• Rotor axial position (thrust) measurement
• High-abrasion environments where cable protection is required
• Hazardous area machinery protection

Ordering Information

Technical Specifications

Installation Guidelines

• Ensure the probe is mounted in a location free from excessive vibration or physical impact that could damage the cable armor.
• Maintain the specified gap voltage requirements during calibration to ensure linear output.
• Use appropriate thread sealing compounds compatible with the industrial fluid environment.
• Ensure the probe cable is securely routed and supported to prevent strain on the ClickLoc connector.
• Ground the system according to local hazardous area regulations when Option 05 approvals are required.

Compliance and Certifications

• CSA: Class I, Division 2, Groups A, B, C, D
• ATEX: II 1 G Ex ia IIC T90 degC...T105 degC
• IECEx: Ex ia IIC T90 degC...T105 degC Ga