Bently Nevada 330130-85-00-00 3300 XL 8 mm Extension Cable

Description

330130-85-00-00 is an 8.5 meter extension cable for 3300 XL 8 mm proximity transducer systems, featuring a standard cable design (Option 00) and no required agency approvals (Option 00). This cable provides the necessary electrical path between the proximity probe and the Proximitor sensor, ensuring correct system calibration and signal integrity for vibration and position monitoring.

This extension cable is engineered for use in 3300 XL transducer systems, maintaining compatibility with 3300 XL 8 mm probes and 3300 XL Proximitor sensors. The cable assembly includes standard shielding to protect the signal from electromagnetic interference in industrial environments. Proper installation of this cable is required to maintain the electrical length characteristics of the system, which are essential for accurate displacement measurements on critical rotating machinery.

Features

• 8.5 meter total length (Option 85)
• Standard cable configuration (Option 00)
• No agency approvals (Option 00)
• Compatible with 3300 XL 8 mm proximity probes and Proximitor sensors
• Constructed for harsh industrial monitoring environments
• Coaxial cable with standardized impedance for Bently Nevada transducer chains

Applications

• Turbine and compressor shaft vibration monitoring
• Rotor axial position measurement
• Critical rotating machinery protection
• Fluid film bearing health analysis

Ordering Information

Technical Specifications

Installation Guidelines

Ensure that the extension cable is routed through protective conduit where possible to prevent mechanical damage or abrasion. Keep the cable away from high-voltage power lines to minimize induced noise. Connections between the probe lead, extension cable, and Proximitor sensor should be tightened to the recommended torque specifications using the provided ClickLoc connectors. Ensure all connections are clean and free of moisture or contaminants before assembly.

Compliance and Certifications

This specific configuration (Option 00 for Agency Approval) does not carry hazardous area certifications. For hazardous area applications, select an appropriate approval option (e.g., CSA/ATEX/IECEx) as specified in the product datasheet.