Bently Nevada 330130-085-02-00 3300 XL Standard Extension Cable

Description

Option 085 (8.5 m cable length) and Option 02 (Standard cable with connector protector) specify this 3300 XL Standard Extension Cable configuration — 330130-085-02-00. This non-contacting transducer system component connects a 3300 XL 8 mm proximity probe to a 3300 XL Proximitor sensor. The 8.5-meter cable matches with a 0.5-meter proximity probe to form a total system length of 9.0 meters, maintaining electrical calibration and signal integrity.

Option 02 specifies pre-installed fluorosilicone connector protectors that isolate the miniature coaxial ClickLoc connections from wet, dirty, or oily environments. Unlike option 00 (unprotected standard cable) or option 01 (armored cable), this configuration offers environmental sealing without the additional weight of stainless steel armor. The gold-plated ClickLoc connectors provide a secure, locking mechanical interface that prevents self-loosening and requires only finger-tight torque for installation.

Features

• 8.5-meter (27.9 feet) standard cable length configured to complete 9.0-meter systems.
• Pre-installed fluorosilicone connector protectors for chemical and environmental sealing.
• Gold-plated brass and beryllium copper miniature coaxial ClickLoc connectors.
• Patented CableLoc design providing up to 330 N (75 lbf) of pull strength.
• Extruded Fluorinated Ethylene Propylene (FEP) outer jacket and cable insulation.
• Compatible with standard-temperature 3300 XL 8 mm proximity transducer systems.

Applications

Used on critical rotating machinery for monitoring parameters such as shaft radial vibration, axial thrust position, eccentricity, and rotational speed. Typical applications include gas and steam turbines, centrifugal compressors, gearboxes, industrial pumps, cooling tower fans, generators, and electric motors in the power generation, petrochemical, water treatment, and heavy processing industries.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

Keep the extension cable coiled neatly and avoid sharp bends that exceed the 25.4 mm (1.0 inch) minimum bend radius limit. When connecting the ClickLoc connectors, tighten them finger-tight only until a distinct click is felt, indicating that the locking mechanism is engaged. For environmental shielding, slide the pre-installed connector protector sleeve fully over the connection. Do not run the extension cable in close proximity to high-voltage lines, and use dedicated protective conduit if physical damage from surrounding equipment is possible.