Bently Nevada 330103-13-23-05-02-00 3300 XL 8 mm Proximity Probe

Description

330103-13-23-05-02-00 is a 3300 XL 8 mm proximity probe featuring an M10 x 1 thread and a non-armored design, configured with a 130 mm unthreaded length (Option 13) and a 230 mm case length (Option 23). This probe is optimized for a 0.5 m system length (Option 05) and utilizes a standard Miniature ClickLoc connector (Option 02) to ensure secure integration within 3300 XL monitoring systems. This unit provides non-contact displacement measurement for critical rotating machinery, including turbine, compressor, and pump shaft vibration and axial position monitoring.

As a core component of the 3300 XL 8 mm transducer system, this probe is designed to work exclusively with the 3300 XL Proximitor sensor and extension cable. The system provides an accurate voltage output proportional to the distance between the probe tip and the observed conductive target, maintaining consistent performance across the specified temperature range. This specific configuration, lacking agency approvals (Option 00), is intended for standard industrial applications where hazardous area certifications are not required.

Features

• M10 x 1 thread configuration (330103 series).
• 130 mm unthreaded length (Option 13).
• 230 mm case length (Option 23).
• 0.5 m total system length (Option 05).
• Miniature ClickLoc coaxial connector, standard cable (Option 02).
• Non-armored probe construction.
• Compatible with 3300 XL Proximitor sensor and 3300 XL extension cables.
• Output proportional to shaft displacement for vibration and position monitoring.

Applications

• Turbine and compressor shaft vibration monitoring.
• Rotor axial position (thrust) measurement.
• General purpose industrial rotating machinery protection.
• High-precision gap measurement in sleeve bearing assemblies.

Ordering Information

Technical Specifications

Installation Guidelines

Ensure the probe is gapped correctly according to the 3300 XL system manual to maintain the linear range. When installing, verify the thread engagement does not exceed 15 mm for M10 x 1 threads to avoid binding. Use proper cable routing practices, keeping the coaxial cable away from high-voltage lines to prevent electrical noise. Ensure the ClickLoc connectors are finger-tight; excessive torque with tools is unnecessary and may damage the connector interface.

Compliance and Certifications

This configuration (Option 00) does not carry hazardous area certifications. For applications requiring CSA, ATEX, or IECEx approvals, choose the appropriate agency approval option during procurement.