Bently Nevada 330130-040-01-05 3300 XL Standard Extension Cable

Description

The 330130-040-01-05 is a 3300 XL Standard Extension Cable configured for a 4.0 meter length, standard cable construction, and international agency approvals (CSA, ATEX, IECEx). This extension cable is a vital component of the 3300 XL 8 mm Proximity Transducer System, facilitating the connection between the proximity probe and the Proximitor sensor. It ensures signal integrity for non-contact eddy-current displacement measurement in critical machinery monitoring applications.

This specific configuration, identified by option code 01 (standard cable) and option code 05 (hazardous area approval), supports standard operating environments where environmental protection such as FluidLoc or armored shielding is not required, while maintaining full compliance for hazardous area installations. Proper selection of the extension cable length is required to ensure the total system length (probe plus extension cable) matches the calibrated 5-meter or 9-meter Proximitor sensor requirement.

Features

• 4.0 meter total cable length (Option 040)
• Standard cable construction (Option 01)
• CSA, ATEX, and IECEx hazardous area approvals (Option 05)
• Compatible with 3300 XL 8 mm probes and 3300 XL Proximitor sensors
• High-frequency signal transmission for vibration and position monitoring
• ClickLoc connector design for secure, reliable attachment

Applications

The 330130 extension cable is used in various industrial sectors, including power generation, oil and gas, petrochemical, and water treatment. Typical installations include:

• Turbine and compressor shaft vibration monitoring
• Rotor axial position measurement
• Critical rotating machinery protection on 3300 XL 8 mm probe systems
• Hazardous area environments requiring CSA, ATEX, or IECEx certification

Ordering Information

Technical Specifications

Installation Guidelines

Ensure that the total length of the extension cable and the probe equals the required length of the Proximitor sensor (e.g., 5 meters or 9 meters). When routing the cable, avoid sharp bends and maintain separation from high-voltage lines to prevent electromagnetic interference. Use the provided connector protectors if required by the installation environment. Grounding and shielding practices must adhere to the specific site requirements for hazardous area installations.

Compliance and Certifications

• CSA (Canadian Standards Association)
• ATEX (Atmospheres Explosibles)
• IECEx (International Electrotechnical Commission Explosive)