Description

This device is a Siemens 6AV7613-0AF32-0BH0, a SIMATIC Panel PC 670 designed for industrial human-machine interface (HMI) and control applications. This specific configuration features a 12-inch TFT display, a Pentium III 500 MHz CPU, and 256 MB of RAM. It is equipped with a 40 GB hard drive and an integrated CD-ROM drive for software installation and data access. The unit is supplied with a U.S. mains cable for operation on 115-230V power systems and comes pre-installed with a German-language version of Windows NT 4.0. Note that this product is considered obsolete, making it suitable for maintaining or repairing legacy automation systems.

Features

• 12-inch color TFT display for process visualization.
• Pentium III 500 MHz processor.
• 256 MB of system RAM.
• 40 GB internal hard drive for operating system and application storage.
• Integrated CD-ROM drive.
• Wide input voltage range of 115-230V AC.
• Pre-installed with Windows NT 4.0 (German).

Applications

• Machine-level operator control and monitoring.
• Process visualization and data acquisition (SCADA).
• Plant floor data logging and reporting.
• Replacement unit for existing SIMATIC PC 670 installations.
• Industrial control systems requiring a legacy operating system environment.

Technical Specifications

Installation Guidelines

1. 1 Panel Cutout and Mounting: Prepare the control cabinet or panel cutout according to the device's mechanical dimensions. Ensure the mounting surface is clean, flat, and rigid. Secure the Panel PC using all provided mounting clamps, tightening them evenly to ensure a proper seal and prevent chassis distortion.
2. 2 Protective Earth (PE) Connection: Connect the chassis to the main protective earth conductor of the control cabinet using a low-impedance connection. This is critical for operator safety and electromagnetic compatibility (EMC). Use a short, large-gauge wire for this connection.
3. 3 Power Connection: After confirming the supply voltage matches the 115-230V range, connect the provided mains cable to a stable, properly fused power source. Route the power cable separately from signal and communication lines to minimize electrical noise interference.
4. 4 Ventilation and Clearances: Ensure adequate ventilation around the unit's rear heat sink. Maintain specified clearances above, below, and behind the device to allow for proper convective cooling and prevent overheating. Do not block ventilation slots.
5. 5 Peripheral and Network Connections: Connect all required peripherals (keyboard, mouse) and network cables. Use shielded cables for all data communication lines and ensure shields are properly terminated to the grounded chassis to maintain signal integrity.