Bently Nevada 330905-00-25-05-02-00 3300 XL NSv Proximity Probe

Description

330905-00-25-05-02-00 is a 3300 XL NSv proximity probe with an M10x1 thread, 0.0 in unthreaded length (Option 00), 2.5 in case length (Option 25), and a 0.5 m total length (Option 05). This probe utilizes a standard miniature coaxial ClickLoc connector (Option 02) and is supplied without hazardous area approvals (Option 00). It is engineered for non-contact displacement measurements, particularly in applications with restricted target areas or tight mechanical clearances where standard probes may not fit.

The 3300 XL NSv proximity transducer system provides reliable shaft vibration and position monitoring for small-bore rotating machinery and high-speed equipment. This probe pairs with 330980 Proximitor sensors and 330930 extension cables to maintain signal integrity over the total system length. The M10x1 thread allows for versatile mounting in machinery housings where space is limited, while the non-armored design supports standard installation environments.

Features

• M10x1 thread configuration for compatibility with tight-clearance housings
• Miniature coaxial ClickLoc connector for reliable signal connection
• Standard cable type without armor for general industrial use
• 0.5 m total probe length optimized for compact transducer systems
• Designed for 3300 XL NSv proximity transducer systems

Applications

• Small-bore machinery and high-speed rotating equipment
• Aeroderivative turbines with limited target geometry
• Shaft radial vibration and axial position measurements
• Machinery where standard 8 mm probes exceed available target space

Ordering Information

Technical Specifications

Installation Guidelines

Ensure the probe is installed with the correct gap setting as specified in the 3300 XL NSv Proximitor Sensor manual. When routing cables, avoid sharp bends and keep away from high-temperature surfaces or moving parts. Use a mounting pad (where applicable) to isolate the Proximitor sensor from the housing ground. Verify all connector interfaces are clean and fully seated to prevent signal noise.

Compliance and Certifications

Complies with EMC Directive 2014/30/EU, RoHS Directive 2011/65/EU, and China RoHS (EFUP 15 years). This unit is rated for non-hazardous locations (Not required approval option).