Bently Nevada 330908-00-16-10-02-05 3300 XL NSv Proximity Probe

Description

The 330908-00-16-10-02-05 is a 3300 XL NSv proximity probe designed for machinery where target area or physical clearance is limited. This configuration features a 1.6 inch case length (Option 16), a 1.0 meter total cable length (Option 10), and a Miniature ClickLoc connector (Option 02). It is specified for use in hazardous areas with CSA, ATEX, and IECEx approvals (Option 05).

Engineered for the 3300 XL NSv Proximity Transducer System, this 5 mm diameter probe provides accurate, non-contact displacement measurements for shaft vibration and axial position on small-bore machinery. The NSv system is specifically optimized for targets that are smaller than those required by standard 8 mm probes, offering improved linearity and stability in confined installations where conventional sensors might experience target interference.

Features

• 5 mm probe tip diameter suited for small-bore targets and reduced clearance applications
• Option 16 case length provides 1.6 inches of physical body length
• Option 10 length defines a 1.0 meter total system length from probe tip to connector
• Miniature ClickLoc connector ensures secure attachment to 330930 extension cables
• 3/8-24 UNF threaded body (Option 00, fully threaded) for installation flexibility
• Compatible with 330980 NSv Proximitor sensors only

Applications

• Aeroderivative gas turbines
• High-speed centrifugal compressors with limited probe mounting space
• Small-bore rotating equipment
• Critical machinery where target geometry restricts standard 8 mm sensor usage

Ordering Information

Technical Specifications

Installation Guidelines

Ensure the probe is installed with the correct gap distance as specified in the 3300 XL NSv manual to maintain linear operation. Verify that the probe tip does not contact the target during operation. Use the provided lock nuts to secure the probe body. Protect the Miniature ClickLoc connector from moisture and contaminants using appropriate connector protectors or by installing in a dry, shielded conduit.

Compliance and Certifications

This unit complies with hazardous area requirements for CSA, ATEX, and IECEx as indicated by Option 05. Ensure site installation adheres to the specific control drawing and local codes for intrinsic safety.