Honeywell CC-PAON01 51410070-175 Experion PKS Series C Non-HART Analog Output Module

Description

The Honeywell CC-PAON01 (Part Number 51410070-175) is a 16-channel non-HART analog output module engineered for process automation applications within the Honeywell Experion Process Knowledge System (PKS) Series C architecture. Operating on the Series C I/O link (IOLINK) mastered by a C300 controller, the module delivers 4-20 mA control signals to field elements such as control valves, actuators, positioners, and variable speed drives.

Designed as an updated functional successor to earlier CC-PAOX01 and CU-PAOX01 hardware models, the CC-PAON01 utilizes the standard AO16 function block in Experion Control Builder. The module mounts directly onto dedicated Series C Input Output Termination Assemblies (IOTA), integrating into single or redundant IOLINK topographies.

In Experion PKS control architectures, the CC-PAON01 supports both non-redundant and 1-on-1 redundant hardware configurations. Following localized power disruptions, single I/O modules complete initialization in 10 seconds (+/- 25%), resuming control loop processing without requiring full system reboots.

Features

• Provides 16 analog output channels dedicated to non-HART 4-20 mA field control loops.
• Interfaces directly with C300 controllers over the Series C I/O link (IOLINK) network.
• Configured and executed in Experion Control Builder using the standard AO16 IOM block structure.
• Serves as the direct functional replacement model for legacy CC-PAOX01 and CU-PAOX01 modules.
• Supports non-redundant (CC-TAON01) and redundant (CC-TAON11) Field Termination Assemblies.
• Rapid module-level initialization completes within 10 seconds (+/- 25%) following power restoration.
• Supports up to 40 redundant IOMs per IOLINK and up to 80 redundant IOMs per C300 controller.

Applications

• Modulating final control elements including 4-20 mA control valves, I/P converters, and positioners.
• Providing analog control speed references to variable frequency drives (VFD) and motor controllers.
• Integrating non-HART analog output field loops into Experion PKS C300 process automation systems.

Technical Specifications

Connections / Interfaces

Installation Guidelines

1. Verify that the module model (CC-PAON01) and part number (51410070-175) match engineering design drawings before installation.
2. Confirm cabinet logic power status and observe ESD protection procedures before handling the module assembly.
3. Align the rear connector of the CC-PAON01 with the designated slot on the CC-TAON01 or CC-TAON11 IOTA base.
4. Press the module onto the IOTA mounting position until the securing latches click into place.
5. Inspect field wiring connected to the IOTA screw terminals to ensure secure wire termination and shielding ground connections.

Configuration / Commissioning / Replacement Guidelines

1. Block Assignment: In Experion Control Builder, assign the channel configuration using the standard AO16 function block.
2. Link Configuration: Ensure the C300 controller IOLINKTYPE parameter is set correctly to support Series C I/O modules.
3. Redundancy Restrictions: When replacing older CC-PAOX01 units with CC-PAON01, note that mixed redundant pairs (pairing a PAOX01 with a PAON01) are not supported; online migration requires identical hardware pairs.
4. Commissioning Verification: Measure loop current across the output terminals using a calibrated meter prior to placing the corresponding control loop into automatic mode.