Omron Ethernet CS1W-CLK23

Description

Facilitating high-speed, peer-to-peer data sharing and message exchanges across industrial networks, the Omron CS1W-CLK23 is a dedicated Controller Link Unit designed for seamless integration into CS1-series PLC systems. This module operates on a wired, shielded twisted-pair network, enabling robust communication between multiple PLCs and host computers without sacrificing processor cycle times. Built for high-density industrial control architectures, it allows systems engineers to establish reliable data links and handle intensive message services within demanding automation environments.

Features

• Flexible Communication: Supports both high-volume data link systems and asynchronous message services for flexible information exchange.
• Scalable Architecture: Up to 8 Controller Link Units can be mounted per CPU Unit, allowing complex multi-tier network topologies.
• Efficient Resource Allocation: Utilizes only 1 unit number allocation on the CS1 CPU bus backplane.
• Low Power Footprint: Consumes 0.33 A at 5 V DC, minimizing thermal load on the system power supply unit.
• Standard Certifications: Complies with UC1, N, L, and CE regulatory standards for global industrial deployment.

Applications

• Automotive assembly line synchronization and inter-PLC coordination.
• Large-scale water and wastewater treatment distributed control systems.
• Food and beverage batching networks requiring high-speed data logging.
• Complex packaging line orchestration and material handling systems.

Technical Specifications Table

Empirical Engineering Insights

Alternative Models & Compatibility

The CS1W-CLK23 replaces legacy Controller Link Units such as the CS1W-CLK21-V1. It maintains backwards compatibility with existing wired twisted-pair Controller Link modules on the same physical segment. However, engineers must verify that the CPU Unit's firmware is compatible with the routing table configurations required by this revision level to prevent routing communication fault codes during startup.

Application Pitfalls & Engineering Notes

Network termination resistors (110 ohms) must be physically enabled at the two extreme end-nodes of the twisted-pair trunk. Failure to install or switch on these terminators will cause high packet-error rates and eventual token loss under heavy electromagnetic interference (EMI) conditions. Keep transmission speed settings uniform across all nodes on the network; unmatched baud rate settings will prevent the unit from joining the active token ring.

Commissioning & Wiring Tips

When routing the shielded twisted-pair communication line, ensure the cable shield is grounded at only one point of the network segment to avoid ground loops. Additionally, run the Controller Link cabling in dedicated, grounded metal conduits isolated from high-voltage AC lines or variable frequency drive (VFD) output motor cables to maximize signal integrity and prevent data corruption.

Installation Guidelines