Bently Nevada 330130-040-00-00 3300 XL Standard Extension Cable

Description

Option 040 (4.0 meters length) and Option 00 (standard cable without connector protector) define this 3300 XL Standard Extension Cable configuration — 330130-040-00-00.

This standard unarmored version contrasts with armored (-01) or connector-protected (-02) variants by offering lightweight, highly flexible routing in environments where mechanical crushing or extreme abrasion risks are minimized. It provides the essential electrical connection between a 3300 XL 8 mm proximity probe and a Proximitor sensor, completing a 5.0-meter or 9.0-meter monitoring loop. When combined with a 1.0-meter probe, it achieves a total system length of 5.0 meters, which matches the calibration of a standard 5-meter Proximitor sensor.

Features

• Cable length of 4.0 meters (13.1 feet) provides necessary extension to complete a 5-meter or 9-meter transducer system.
• Standard unarmored coaxial cable design (Option 00) optimizes flexibility for tight-bend conduit installations.
• ClickLoc gold-plated connectors resist corrosion and require only finger-tight torque, locking with an audible click.
• Fluoropolymer (FEP) outer insulation and cable jacket resist moisture, oils, and chemical exposure in industrial environments.
• Operating temperature rating up to 177 degC (350 degF) covers standard rotating machinery environments.
• Option 00 agency approval indicates the cable is configured for general purpose or non-classified areas where hazardous certificates are not required.

Applications

Typical heavy-industry scenarios include steam and gas turbine shaft vibration measurement, generator bearing housing monitoring, industrial gearbox alignment tracking, and electric motor shaft displacement analysis within Bently Nevada 3300 XL 8 mm transducer setups.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

Avoid routing cables near high-voltage lines or AC electrical noise sources. Tighten ClickLoc connectors finger-tight until an audible click is felt; do not use tools or pliers unless joining non-XL connectors. Pull cables carefully through conduit, avoiding sharp bends or excess pulling tension. Maintain a bend radius of at least 25.4 mm (1.0 in) along the entire cable run to prevent impedance mismatch or mechanical fatigue.

Compliance and Certifications

This General Purpose option (CC=00) does not carry specific hazardous area certification markings. It is intended for installation in non-classified, general purpose industrial environments.