Bently Nevada 330173-00-06-10-02-00 3300 5mm Proximity Probe

Description

330173-00-06-10-02-00: This metric M8 x 1 threaded probe specifies a 3300 5 mm proximity probe configuration with an unthreaded length of 0.0 mm (fully threaded), an overall case length of 60 mm, a total system/cable length of 1.0 metre, and a standard miniature ClickLoc coaxial connector without armor or hazardous area approvals.

The transducer system converts the distance between the 5.2 mm probe tip and a conductive target surface into a stable electrical voltage. Operating on the eddy-current principle, this system is primarily used for monitoring static shaft position, axial displacement, and dynamic shaft vibration in high-speed rotating machinery with limited mounting clearance. This configuration ensures complete interchangeability across compatible 3300 5 mm Proximitor sensors and extension cables, eliminating the need for individual component matching or bench calibration.

Features

• M8 x 1 metric thread with a fully threaded case length of 60 mm (0.0 mm unthreaded portion) for compact mounting holes.
• Patented TipLoc molding method which increases the mechanical bond strength between the 5.2 mm probe tip and the stainless steel body.
• 1.0 m FEP insulated coaxial cable with standard miniature coaxial ClickLoc connector.
• Unarmored cable configuration for clean-room, standard panel, or protected conduit routes.
• Non-contact eddy-current measurement system compatible with 3300 XL 5 mm Proximitor sensors and extension cables.
• 2.0 mm (80 mils) linear range beginning at 0.25 mm (10 mils) from target to provide position or vibration signals.

Applications

• Radial shaft vibration and axial position measurements on fluid-film bearing machinery.
• Speed sensing and Keyphasor phase reference signal generation in space-constrained installations.
• Machinery protection on industrial turbines, compressors, pumps, and motors with compact envelopes.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

• Cable routing: Avoid running coaxial cabling near high-voltage circuits or transient electric conduits to minimize EMI/RFI noise interference.
• Connector Protection: Keep the connection clean and dry. In non-oil applications, apply silicone self-fusing tape to protect the probe-to-extension cable link. Do not use silicone tape inside areas exposed to turbine oil.
• Mounting Torque: Do not exceed the maximum tightening torque of 7.3 N-m (65 in-lb) during threaded case mounting to prevent deformation of the M8 housing. Recommended torque is 5.1 N-m (45 in-lb).
• Probe Gap Setting: Ensure physical gap matches 1.27 mm (50 mils) to align the measurement accurately with the center of the Proximitor sensor's linear range.

Compliance and Certifications

• EMC Directive 2014/30/EU (EN 61000-6-2, EN 61000-6-4)
• RoHS Directive 2011/65/EU
• FCC Part 15