Bently Nevada 330930-040-00-00 3300 NSv Extension Cable

Description

Unarmored coaxial design with a 4.0-meter physical length and no agency approvals specifies the 330930-040-00-00 3300 NSv Extension Cable configuration. This specific length allows building 5.0-meter or 7.0-meter overall system lengths when paired with corresponding 3300 NSv proximity probes and Proximitor sensors. The unarmored coaxial cable utilizes gold-plated ClickLoc connectors to prevent signal drift or loose mechanical connections under machine vibration.

Engineered for narrow-clearance and small-target applications, the 3300 NSv system requires tight mechanical and electrical tolerances. Unlike armored variants such as those with stainless steel sleeving, this unarmored version provides maximum flexibility in tight routing channels and conduits where standard 25.4 mm (1.0 in) minimum bend radii are needed. It does not include a pre-installed connector protector, making it suitable for clean conduit runs or dry installations.

Features

• 4.0-Meter Cable Length: Opted under the 040 length configuration, designed to match the system-level requirements of 5.0-meter or 7.0-meter transducer loops.
• Unarmored Construction: Option 00 provides a flexible, lightweight outer jacket with no stainless steel armor, facilitating simple installation in protective conduits.
• Gold-Plated ClickLoc Connectors: Secure connections are ensured via self-locking coaxial couplers that resist loosening under machine-induced vibration.
• Standard FEP Outer Jacket: Resists a wide range of chemical exposures, including process compressor gasses and machinery fluids.
• Interchangeability: Backward-compatible and electrically interchangeable with older Bently Nevada 3300 RAM proximity probe and cable assemblies.

Applications

The 3300 NSv proximity system is typically used in the following industrial contexts:

• Non-contact shaft vibration and axial position measurements on small-bore machinery.
• Aeroderivative gas turbines and high-speed centrifugal compressors.
• Fluid-film bearing monitoring where target geometry is extremely limited.
• Conduit-protected pathways on power generation and industrial rotating equipment.

Ordering Information

Technical Specifications

Connections and Interfaces

Installation Guidelines

• Bend Radius: Do not exceed the minimum bend radius of 25.4 mm (1.0 in) during routing to prevent attenuation or damage to the internal coaxial core.
• Connector Protectors: Although this option (00) does not include pre-installed connector protectors, using them is recommended if the cable connections are exposed to liquid spray or moisture.
• Silicone Tape Application: Use the self-fusing silicone tape supplied with the cable to wrap and isolate the probe-to-cable connector interface. Do not use silicone tape inside machine casings where turbine oil is present.
• Conduit Protection: Route the unarmored cable inside a dedicated protective metal conduit to safeguard against mechanical abrasion or cutting hazards.
• Connector Torque: Tighten coaxial connections finger-tight. If using tools, do not exceed the maximum allowable torque of 0.56 N m (5 in lb).